STANDARD EXTERNAL CIRCLIPS EUROPEAN SPECIFICATIONS D1400 (Continued) Incorporating DIN 471 & BS3673 Pt.4 14 Beam dimension on Shaft or in boge Free

External Circlips The most common form of axially fitted circlips for bores with grooves. The circlip has a large free diameter and gap width, consequently it fits more tightly into the groove and provides higher and more uniform thrust load capacity. Enquiry>> Dimension Table External Circlip Heavy Series : DIN 471 - IS 3075 Enquiry>>

Standard External Circlips: DIN 471 Metric. Most sizes over 170mm are without lugs. Measurements in mm & kN. Shaft. Circlip Dimensions.

Every effort has been taken to ensure that the data listed in this catalogue is correct. Finer Power Transmissions P/L will not accept liability for any damage or loss caused as a result of the data in this catalogue. Finer Power Transmissions P/L | wwwfinerp. t

DIN 472. DIN 472 Internal Circlips, it also called retaining rings for bore; The dimension of DIN 472 as below: Bore. Circlip Dimensions. Groove Dimensions. B.

STANDARD EXTERNAL CIRCLIPS EUROPEAN SPECIFICATIONS D1400 (Continued) Incorporating DIN 471 & BS3673 Pt.4 14 STANDARD INTERNAL CIRCLIPS - EUROPEAN SPECIFICATIONS D1300 Incorporating DIN 472 & BS 3673 Pt.4 15 STANDARD INTERNAL CIRCLIPS - EUROPEAN SPECIFICATIONS D1300 (Continued) Incorporating DIN 472 & BS 3673 Pt.4 A" in in siZOS

Standard External Circlip: IS 3075, DIN 471. Material: Carbon Spring Steel Circlips. Groove. Size. Size. Tolerrance. Tolerance size. Tolerrance.

Engineering Information, Conversions and Calculations. D1300 + D1400 CIRCLIP DIMENSIONS. The dimensional charts forD1300 Metric Internal CirclipsandD1400 Metric External Circlipsto DIN 471 and DIN 472.. Dimensions shown are in mm, if you wish to convert to Inches, please use ouruniversal converter.. D1300 METRIC INTERNAL CIRCLIP DIMENSIONS - DIN 472

Heavy Duty External Circlips: To DIN 471 Metric. Design is based upon the standard external series but with increased thickness and in the case of the American series increased section depth. Heavy duty Circlips are used to withstand shock loads and also to resist conical deformation where, for example, large abutment radii are present.

Circlips - External Circlips - External SIZE CODE SHAFT GROOVE (G) CIRCLIP (F) S G Tol. W Tol. n (min.) d~ t Tol. D Tol. C C1 L (max) b~ h (min) 1400-29 29 27.6 (+)0.00 (-)0.21 1.6 (+)0.14 (-)0.00 2.1 0.7 1.5 (+)0.00 (-)0.06 26.9 (+)0.21 (-)0.42 39.1 37.2 4.8 3.4 2 1400-30 30 28.6 1.6 2.1 0.7 1.5 27.9 40.5 38.6 5 3.5 2

Unless specified, all dimensions are in millimeters Some products are changing from DIN to ISO standard. If dimensions are critical, please check with TR what